I think everything else is pretty much at the defaults.Įdited 1 time(s). I also set it to do three loops at the start to make sure the PLA is flowing well before it starts printing the object. I set the top and bottom solid layers to 5 instead of 3. 25 MM for better quality and the first layer height I set to. I also changed the temperatures for the first and subsequent layers to 185C.įor the print settings, I changed the layer to. I measured the actual filament I'm using and it was 1.66 MM, so I set it to that. Here is what I changed from the default.įor the filament, I added a new profile called white PLA. I simply took the default settings and made a couple of changes. I have not made any changes directly to the ini file. I actually changed that to 0 since I didn't want a super thick first layer. When I look at the default print profile, under advanced, extrusion width, the only non-zero value is the first layer setting. The default for those are all set to zero. I also attached the STL and gcode files to this message.ģD Printer: Reprap Original Mendel with RAMPS 1.4 electronics, j-head MK V-BV 0.4MM extruder, Wade's geared extruder, setup for 1.75MM filament I would think those are considered perimeters, but it's not treating them that way. I cannot find any settings in slic3r to control the top and bottom of a part. The part is supposed to be 25 MM x 25 MM x 5 MM with a recessed area of 15 mm x 15 mm x 2.5 mm. As you can see, the middle area is all crossing infill with no solid layers at all. The recessed part in the middle should be half the depth of the part. You can see the solid perimeter on the outside and inside, but there was not solid layer on the bottom or top. The attached CAD picture is what I expected the part to look like. When I create an object in FreeCAD, export it to an STL, slice it with slic3r, and print it, the top and bottom layers are not solid, they are the infill pattern. I have my printer setup and printing pretty well, but I have one issue. I'm pretty new to 3D printing but I'm making progress.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |